|
Audix ADX20i-P Clip-On Condenser Instrument Microphone The ADX-20i is a pre-polarized condenser microphone designed to handle a wide variety of clip-on applications. The ADX20i is sonically superior as well as aesthetically pleasing and is ideally suited for saxophone, trombone, trumpet and other brass instruments. With a smooth uniform response over a frequency range of 40 Hz - 20 kHz, the ADX-20i provides a rich, warm sound not typical of microphones this size. It is machined from solid brass and has a low reflective black e-coat finish.
The ADX-20i operates on phantom power (9-52 volts) with the preamp module provided (APS-910). It may be used in battery mode with optional phantom power adapter (APS-911). The ADX-20i can be utilized with a wireless system. Depending on the brand of wireless and the connector configuration of the instrument body pack, the ADX-20i connector would need to be modified accordingly. Low noise electronic circuitry, and balanced low impedance output allow for interference free performance even with long cable runs. Specifications: -
Transducer Type: Condenser (pre-polarized) -
Frequency Response: 40 Hz - 20 kHz -
Polar Pattern: Cardioid -
Output Impedance: 250 Ohms balanced -
Open Circuit Sensitivity: 5.2 mV -
Equivalent Noise Level: 29 dB (A weighted) -
Signal to Noise Ratio: 65 dB (ref 1k @ 1 Pascal) -
Power Requirements: 9 - 52v phantom -
Maximum SPL: 130 dB -
Cable/Connector: Shielded 6 cable terminating to a miniature 3 pin XLR-f -
Phantom Adapter: mini XLR male - XLR male -
Polarity: Positive voltage on pin 2 relative to pin 3 of output XLR connector -
Housing: Machined Brass -
Gooseneck: Flexible steel -
Weight: 1.7 oz/4.7 grams (without cable)
|
