RECEIVER SPECIFICATIONS |
| |
| Receiving System | Dual independent RF sections, automatic-switching diversity |
| |
| Image Rejection | 60 dB typical |
| |
| Signal-to-noise Ratio | 115 dB at 40 kHz deviation (IEC-weighted), 75 kHz maximum modulation |
| |
| Total Harmonic Distortion | <=1% (10 kHz deviation at 1 kHz) |
| |
| Sensitivity | 20 dB΅V (S/N 70 dB at 5 kHz deviation, IEC-weighted) |
| |
| Intermediate Frequency | 65.75 MHz, 10.7 MHz |
| |
| Audio Output - Microphone | 25 mV (at 1 kHz, ±5 kHz deviation, 10k ohm load),
transformer isolated and balanced
(ATTN switch at "0") |
| |
| Audio Output - Instrument | 50 mV (at 1 kHz, ±5 kHz deviation, 10k ohm load),
transformer isolated and balanced
(ATTN switch at "0") |
| |
| Audio Output Attenuator (ATTN) | Three-position switch: 0 / -6 / -12 dB |
| |
| Output Connectors (Microphone) | XLRM-type, balanced |
| |
| Output Connectors (Instrument) | 1/4" (6.3 mm) TRS balanced phone jack |
| |
| Headphone Output | Connector: 1/4" (6.3 mm) TRS ("stereo") phone jack.
Power Output: 10 mW + 10 mW into 32 ohms (at 1 kHz, ±5 kHz deviation); maximum output: 220 mW + 220 mW into 32 ohms.
Headphones switchable between Channel 1 and Channel 2. |
| |
| External Mute | 1/4" (6.3 mm) TS unbalanced phone jack, each channel |
| |
| Antenna Power | DC 10V-12V, 20 mA (BNC-type jack) |
| |
| Computer Interface | Type: Ethernet, 10BaseT mode
Connector: RJ-45
Proprietary Software: supplied on CD-ROM |
| |
| Power Supply | 100-240V AC 50/60 Hz, 15W |
| |
| Pass-through AC Power Outlet | 100-240V AC 50/60 Hz, 5A maximum |
| |
| Dimensions | 18.98" (482.0 mm) W x
1.74" (44.0 mm) H x
10.85" (275.5 mm) D |
| |
| Net Weight | 8.8 lbs (4.0 kg)
(without accessories)
|
| |
| Accessories Included | Detachable IEC-type AC power cable; two flexible UHF half-wave antennas; link cable; IEC-type AC pass-through cable; front-mount antenna cables and connectors; CD-ROM with computer control interface software; AEW-TB44 transmitter bag |
| |
